Fly ash bricks machine manufacturer in Odisha

Q Green Techcon builds hydraulic fly ash brick making machines and supplies them to producers across Odisha. The models below are the standard machines in the range. Each one is selected by the output a plant needs per shift, and the quoted figures assume a standard brick size, so the number changes when the brick dimensions change.

Machines in the range

QGH Smart. The first machine in the range, intended for producers planning 10,000 to 12,000 bricks per shift. It has a 40 tonne hydraulic pressing capacity, produces 3 bricks per stroke and runs at 6 cycles per minute, on a pallet of 450 mm x 300 mm x 18 mm. A pre-feed system and a 300 kg pan mixer are available as options.

QGH 14. One of the builder series machines, suited to 14,000 to 15,000 bricks per shift. It has a 50 tonne hydraulic pressing capacity, 4 bricks per stroke and 6 cycles per minute, on a pallet of 600 mm x 300 mm x 18 mm, with the same optional pre-feed and mixer.

QGH 17. The other builder series machine, for 16,000 to 17,000 bricks per shift. Its specification follows the QGH 14: 50 tonne pressing capacity, 4 bricks per stroke and a 600 mm x 300 mm x 18 mm pallet, running at 7 cycles per minute.

QGH 25. For plants working at 15,000 to 20,000 bricks per shift. It has an 80 tonne hydraulic pressing capacity, produces 6 bricks per stroke and runs at 7 cycles per minute, on a pallet of 800 mm x 300 mm x 18 mm.

QGH 25A Twin. A twin press machine for 23,000 to 24,000 bricks per shift. Two 80 tonne presses together give 12 bricks per stroke at 7 cycles per minute, on an 800 mm x 300 mm x 18 mm pallet.

Options and configuration

• Pre-feed system, available across the range

• Pan mixer, 300 kg, 600 kg or 1,000 kg according to model

• Pallet lengths of 450 mm, 600 mm or 800 mm, all 300 mm wide and 18 mm thick, according to model

• Moulds made to the brick and block sizes the plant intends to produce

Shift output is quoted against a standard brick size. A larger brick means fewer pieces per stroke and a lower figure per shift, so it is worth sizing the machine against the products a plant actually expects to sell rather than against the headline number alone.

Why fly ash bricks suit the Odisha market

Odisha has a large concentration of thermal power generation and metals processing, which makes fly ash and pond ash readily available as raw material close to where bricks are made. Because the bricks are pressed and cured rather than fired, production needs no kiln and no topsoil, and the ash is put to use rather than stored.

On site, the difference a builder notices is consistency. Pressed bricks come out to a repeatable size with straight edges and flat faces, which speeds up masonry, reduces plaster consumption and lowers breakage in handling. In a state building at the pace Odisha is, that predictability matters as much as the unit cost.

Other equipment

Along with the fly ash brick machines, Q Green Techcon manufactures concrete block machines, paver block machines and material handling equipment. The press, the mixing arrangement and the handling equipment can therefore be specified together from one supplier.

Setting up a plant

Machine selection starts with the output needed per shift, the brick and block sizes to be produced and the space available on site. Mixer capacity, pre-feed and the handling layout follow from those decisions. Q Green Techcon delivers machines throughout Odisha and arranges visits to installed plants for buyers who want to see a machine running before they order.